In the kit you will find two plastic clips that look like this.
There is a single screw that attaches each clip to the data projector mount. All you have to do is find two convenient holes somewhere near the two front corners of the mount and do the screws up. We usally manage to fit these with no tools as we supply them with easy to use wingnuts (as shown in the picture above).
There is a single screw that attaches each clip to the data projector mount. All you have to do is find two convenient holes somewhere near the two front corners of the mount and do the screws up. We usally manage to fit these with no tools as we supply them with easy to use wingnuts (as shown in the picture above).
When the two clips are attached, press the 3Pi mount tube into them so that it is parallel with the front of the projector mount. The tube will now be held securely in place.
You then simply screw the wiimote to the swivel at the end of the mount (our 3Pi power insert has a moulded in thread for this purpose) and plug the power cable into the wiimote.
You then simply screw the wiimote to the swivel at the end of the mount (our 3Pi power insert has a moulded in thread for this purpose) and plug the power cable into the wiimote.
This should all take you less than 5 minutes.
No comments:
Post a Comment